Printing graphics
=================

  Printing of bitmap images is currently supported by 4 printer drivers:
  Canon, Epson, HP, Postscript/Apple.
  The Canon printer driver is used for all Canon BJ printer and for IBM ProPrinter.
  The Epson printer driver is used for all Epson printer of the RX,FX,LQ family.
  The HP printer driver is used for all HP printers (Deskjet, Laserjet)
  The Postscript printer driver is used for all Postscript printers
  and for the Apple Laserwriter.
  

  Printing through a parallel port:
  ---------------------------------

  This applies to directly connect printers and is likely the choice
  when printing from the S3a-emulator.
  

  Printing through a serial interface:
  ------------------------------------

  Using the serial interface you can print directly to a printer or
  you can print to a printer connected to a host computer through
  MCPRINT, RCOM, RPRINT.
  

  Printing bitmapped images through a serial interface can be tricky,
  because bitmaps can contain the whole range of characters including
  control characters used by the serial communication method.

  If you print graphics through a serial interface you must swith software
  flow control (handshaking) off - do not use a combination that includes XON/XOFF.

  You can use hardware flow control, but your printer may not support it.
  If you still experience garbled printouts, set the baud rate lower to
  allow your printer to keep up with the data.


  Printing into a file
  --------------------

  You can direct the output into a file (on the palmtop or on a host computer)
  and you can later copy that file to a printer (e.g. COPY printfile LPT1 /b).

  You can even set the file name directly to the print port (e.g. REM::LPT1) for
  immediate output (MCLINK or RCOM must be active).
  
  This can be a nice way to sidestep the communication problems described above.